Globalink Support                Help is only a click away.         Globalink Cisco Linksys Device Setup

Home |Linksys PAP2 | Linksys RT31P2| |Linksys SPA-9000 PBX|Linksys SPA941 IP Phone

• Linksys PAP2 manual setup for Porta switch
  Your setup may vary depending on your specific sip server.

• Linksys Setup on Porta VoIP Switch using our Auto Provisiong Feature for sip6.iglobalink.net

Do the following only if Support has setup a MAC address IP Phone Profile for you.  Otherwise click here.

STEP 1
You must first determine what IP address your linksys device was assigned.  You need to pick up the phone attached to the Line 1 jack and dial:

                         **** (four asterisks)

then dial:     110 #

and you will be told the IP address of your device (e.g. 192.168.1.100)

STEP 2
Please go to any browser on your computer which is on your network and enter the address:

                   http://<IP ADDRESS>/

(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

example by typing http://192.168.1.100 

STEP 3

Please login as admin in advance mode and find the provisioning tab. 

Please do the following  :- (please contact Globalink Support for your server details)

Provision Enable equal to Yes
Resync on Reset equal to Yes
Profile Rule equal to [--key $B]http://216.52.166.186/server/$MA.cfg

(you will need to know your "server" which will be given to you by support)

eg sip3.iglobalink.net will be http://64.76.241.176/16/$MA.cfg 

STEP 4

Save your settings and give at least 1 hour for our server to automatically reconfigure your device. All future changes including firmware updates will be done by our server.